Ford wing beat start jitter

Why does Ford's wing beat always shake at the start? The most common reason is that the throttle valve is too dirty or the injector has too much carbon deposit. It may also be caused by uneven transmission clutch, insufficient or deformed pressure plate, flywheel failure, hydraulic torque converter failure and other reasons. It is recommended to contact 4S shop for inspection and maintenance. When there is too much carbon deposit in the engine, the gasoline sprayed by the fuel injection head will be absorbed by a large amount of carbon deposit during cold start, which makes the cold start mixture too thin and difficult to start. In this case, it is easy to start the car only if the gasoline with carbon deposits is saturated. After the car starts, the gasoline adsorbed on the carbon deposit will be sucked into the cylinder by the vacuum suction of the engine for combustion, which will make the mixture thicker and the combustible mixture of the engine thinner and thicker, leading to cold start. The lower the temperature, the more oil is needed for cold start and the more carbon is deposited, which will affect the success of cold start. It is inevitable that the engine will produce carbon deposit, but when the engine has too much carbon deposit, it will lead to poor engine work and cause different faults. Solution: Clean the oil circuit, check whether the idle motor has carbon deposit and clean it. Or drive for a while, low speed and high speed, and increase the engine speed. The purpose of this is to increase the air intake and gasoline flow of the engine, which is helpful to remove the carbon deposit of the injector.