How does Nissan Sylphy tighten its belt?

Pacific Auto Network first removes the fixing screws and clips of the front fender (right side), and then removes the front fender from the wheel housing. And keep enough working space, and then adjust the tension of the drive belt by rotating the adjusting bolt B. If it is necessary to remove the belt for inspection, loosen the lock nut A of the single pulley 5 and remove the belt. During installation, pull the idler pulley 5 in the loosening direction, and then temporarily tighten the lock nut A to a torque of 1.4Nm.

Adjustment method of Nissan Sylphy air conditioning belt: firstly, remove the fixing screws and clips of the front fender (right side) and remove the front fender from the wheel housing. And keep enough working space, and then adjust the tension of the drive belt by rotating the adjusting bolt B. If it is necessary to remove the belt for inspection, loosen the lock nut A of the single pulley 5 and remove the belt. During installation, pull the idler pulley 5 in the loosening direction, and then temporarily tighten the lock nut A to a torque of1.4n-m. ..

If the fan belt of diesel generator set is too loose, it will slip, which will reduce the speed of fan and water pump, and then affect the heat dissipation performance of generator set. Too tight will also aggravate the wear of shaft and bearing.

Because this car is an electronic throttle with adaptive throttle opening, it needs to be re-matched after cleaning. When matching, insert the key first, turn it on, but don't touch the car. Turn off the key in two seconds. Then turn it on again, and press the accelerator pedal to the bottom for 3 to 5 times at the same time, then turn off the key, and finally turn on the key to take a taxi, and the matching can be completed.