Do you want to match the old POLO after cleaning the throttle?

Air entering the engine needs to pass through the throttle valve, which is very easy to accumulate dust. When there is too much dust, the air entering the throttle will be blocked by dust at the same opening, and the air actually entering the engine will be less. In this case, it is necessary to clean the throttle to ensure that the throttle can accurately control the amount of air entering the engine.

Too dirty throttle will lead to power loss, unstable idle speed, and serious engine failure lights. Therefore, it is necessary to clean the throttle regularly.

Extended data:

Precautions:

After cleaning the throttle, the throttle shaft and other parts can be lubricated immediately to improve the response speed, and the idling solenoid valve and stepping motor can be cleaned and lubricated, which is difficult to repair after cleaning, delaying the regeneration speed of carbon deposits, and assisting in softening and cleaning the carbon deposits in the intake manifold.

The four screws that fix the throttle can be screwed by hand first, because the hand is sensitive, so it is not necessary to screw the screws directly with a sleeve, and then tighten them with a tool. Then plug in the plug, and the installation of the plug needs to be strengthened. When you hear a click, it means it's fixed.

After installing the throttle valve, you can install the hose. There will be two small grooves on both sides of the hose, one large and one small, aiming at the raised marks on both sides respectively. Both ends of the hose should be completely covered. If the installation is difficult, you can twist it left and right.

Baidu encyclopedia-throttling

Baidu encyclopedia-Volkswagen polo