Where is Camry's exhaust valve?

The exhaust valve of Pacific Auto Network is also called oil separator and pressure control valve. Installed between the compressor outlet and the condenser inlet to improve the heat transfer effect of the condenser and evaporator through separation. Some are on the cylinder block, some are on the valve cover, and some are directly integrated on the valve cover. Replacement method of automobile waste gas valve 1: Open the front cover and remove the upper cover of the engine to see the position of the waste gas valve.

It is understood that the waste gas valve is also called oil separator and pressure control valve. Installed between the compressor outlet and the condenser inlet to improve the heat transfer effect of the condenser and evaporator through separation. Some are on the cylinder block, some are on the valve cover, and some are directly integrated on the valve cover.

Replacement method of automobile waste gas valve

1: Open the front cover and remove the upper cover of the engine, and you can see the position of the waste gas valve.

2: Unplug the hose connecting the wastegate and the intake manifold.

3: Pull out the four plugs of the live wire coil, and the four plugs will be taken out together, but a single plug cannot be taken out. Then pull out coils 3 and 4 by hand, remove a circle of screws around the waste gas valve with T30 flower board, and then remove the waste gas valve.

4. Clean up the oil and impurities on the valve cover, directly install the new waste gas valve, and then install everything in sequence.

The above is an introduction to the position of automobile waste gas valve. In addition, remind the waste gas valve to buy a genuine factory with good quality, otherwise it will be broken in a short time. If you need to know more about the automobile waste valve, please continue to pay attention to the environmental pollution common sense column of Baibai Safety Net.