Where is the Volkswagen LaVida sensor?

The position of Volkswagen LaVida sensor is as follows:

1. oxygen sensor: the oxygen sensor is installed on the exhaust pipe, which is used to monitor the burnt gas and judge whether the engine is fully burned or not, and the mixture is too thin or too rich;

2. Wheel speed sensor: The wheel speed sensor is usually located in the front wheel brake disc, and mainly collects the vehicle speed to judge whether there are signs of slipping. So there is a special sensor to collect the wheel speed of the car to complete this work, which is generally installed on the hub of each wheel. Once the sensor is damaged, ABS will fail.

3. Water temperature sensor: The water temperature sensor is installed beside the thermostat to convert the temperature of the cooling water into an electrical signal, increase the fuel injection amount or ignition advance angle at low temperature, prevent explosion at high temperature and delay the ignition advance angle;

4. Intake pressure sensor: generally installed at the throttle. As the name implies, the intake pressure sensor senses a series of resistance and pressure changes when the engine speed and load are different, and converts them into voltage signals for ECU to correct the fuel injection quantity and ignition timing angle. If something goes wrong, it will cause problems such as difficult ignition, unstable idle speed and weak acceleration.