I want to buy a 2.0mt luxury wing god and ask some modification questions.

Hello, I have spent more than 40,000 yuan on refitting, because I am also a novice at refitting, and some parts have been changed again and again, and I want to change them.

If the best accessories from my current experiment are estimated to be around 20,000 to 30,000,

Let me make a list for your reference:

-

Mitsubishi Wing God changed to EVOX style surround (East Wang Yang ABS material, front and rear, left and right, split kit) RMB-3600.

EVOX tail (ABS material, integrally formed. Excluding) RMB: 350.

Open the hood, resin fiber: 500 yuan.

(At present, all the exterior parts made of wing-god ABS material available in China are made in Taiwan Province Province, with the best quality and stitching degree, and the price is cheaper than that of imported ones. There is basically no difference after wearing them. )

-

centre

Yafandi MI506 18 inch RMB- 1200

tyre

Dongyang DRB 225/45 R18 RMB-1200

My wing god uses this now. Yafendi is made in Malaysia, and the forging process is not expensive.

Wheels below 1000 yuan are basically high imitation and are not recommended.

Toyo's DRB is a high-performance sports tire with excellent performance and low price.

-

Air inlet:

K & ampn (Apollo air intake kit) RMB- 1600

Exhaust:

Boulder SRD (middle section+tail drum suit) RMB-8200

-

Brake calipers:

TTSPORT model: TTS- 160 6 piston caliper set (355MM split cable disc) RMB-7500.

TTSPORT model: TTS-240 small 4-piston caliper set (330MM split cable disc) RMB-5 100.

Brake master cylinder:

EVO brake master cylinder (disassembled parts): RMB-550 (it must be replaced after replacing the multi-piston caliper, and the original pump is not strong enough).

-

Shock absorption:

KYB sports SR blue bucket shock absorber before and after 4:3400 yuan

Spring:

Thai Ndjeng short spring (made in taiwan) front and back four: RMB-750.

(It is not recommended to install a twisted tooth shock absorber below 10,000 yuan. Because of the sacrifice of great comfort, the twisted tooth shock absorber was replaced, RMB: 5200.

The control is good, and the small rotten pits on the road surface will be reflected, but the uneven road conditions feel obvious and super uncomfortable.

In short, it's like having no shock absorber.

-

Ignition coil:

CARSPEED (competitive suit) 4800 yuan

Electronic rectification:

Pivot (VS-M purple) Raytheon electronic ballast: 500 yuan

Electronic throttle:

Wind supercharger 4-mode adjustable electronic throttle/throttle controller (4-segment adjustable) 800 yuan

Vehicle pull rod:

TCR Wing God 13 set: RMB- 1700 (the cheapest tie rod of this brand has good performance and high cost performance, and 13 set is available).

-

The above is the best combination of wing god modified parts, which I got after my experiment.

There is also an ECU brush, and the price here in Guangdong is:

Soft brush ECU- 100 Yuan

(It can be adjusted now, and it is 100 every time. Generally, the trial period is 48 hours, during which it can be repainted free of charge until it is satisfactory. Recharge in 48 hours. )

Hard brush ECU, RMB -2000 or so,

When installing hardware, there are preset schemes with different performances, which you can brush at any time. However, the scheme is fixed and cannot be adjusted, so if the scheme is changed, the hardware version must be updated. )

-

The following are candidate parts:

If you don't want to change horses with a ratio above 180, you can change the middle exhaust section and tail drum into other cheaper ones.

Good quality and performance;

DEX (made in Taiwan Province Province).

Middle section: RMB-1800 yuan.

Tail drum: double drum and double outlet RMB-2800.

The quality is good, but the performance is average.

MX-II (Residential Property)

Middle section: RMB-1600 yuan.

Tail drum: (street drum, double drum, double outlet) RMB: 1300~ 1400.

R. temas

Middle section: RMB-1500 yuan.

Tail drum: (M drum, 3rd generation, single drum and double output) RMB: 1400~ 1500.

-

Brake calipers:

GTR R3X series disassembly parts, front four pistons and rear two pistons (without brake disc) RMB:2800.

(I used this when I first changed it, and it felt good. It is enough not to change power. 2.0MT is replaced by 180 ma. This caliper is not recommended. )

Enlarge the brake disc:

SRQ carbonized hole line integrated disc (front 355MM):RMB- 1600

SRQ carbonized hole line integrated disk (back 338MM):RMB- 1400

Brake steel throat:

EPECA (4 set of 4): RMB -520 yuan

Brake pads:

Jin Qilin (distinguished type, 600-degree high temperature, 8 cars): RMB-300

-

TTSPORT model: TTS- 140 big four-piston caliper set (330MM split cable disc) RMB-6000.

UPSOAR model: 270 large 4-piston caliper set (330MM perforated disc) RMB-5800

UPSOAR model: 178 small 4-piston caliper set (300MM perforated disc) RMB-4300