Where is Nissan Sylphy sensor?

The sensor position of Nissan Sylphy is different, so is the sensor position. Specifically, the position of Nissan Sylphy sensor is as follows: 1. Oxygen sensor: installed on the exhaust pipe, it monitors the burnt gas and judges whether the engine is fully burned and whether the mixing degree is too thin or too rich. 2. Wheel speed sensor: generally located on the front wheel brake disc, it is used to collect the vehicle speed and judge whether the vehicle is slipping. Sensors are usually installed on the hub of each wheel. Once the sensor is damaged, ABS will fail. 3. Water temperature sensor: it is installed next to the temperature controller and converts the temperature of cooling water into an electrical signal. Increase the fuel injection or ignition advance angle at low temperature, prevent explosion at high temperature and delay the ignition advance angle. 4. Intake pressure sensor: generally installed on the throttle. The sensor can sense the difference between engine speed and load, a series of resistance and pressure changes, and convert them into voltage signals for ECU to correct fuel injection quantity and ignition timing angle. If it fails, it will cause problems such as difficult ignition, unstable idle speed and weak acceleration. In a word, due to the different positions of Nissan Sylphy sensors, the positions of the sensors are also different, so we need to deal with them according to the specific situation when checking and maintaining.