Where is the idle screw of the electronic throttle of Changan Automobile?

1, before you start, you need to wait for the machine to cool down before starting the next steps. It's not that the ironing machine can't be cleaned, but mainly to protect your little hand from being burned.

2. Unplug the car key, open the engine compartment cover and support it.

3. Remove the negative wire of the battery, which must be removed, otherwise it will be difficult to correct the car motherboard after cleaning.

4. Remove the plastic cover of the engine.

5. Loosen the clamping screw falling into the air pipe with a screwdriver and pull out the air inlet pipe.

6. Remove the three fixing screws of the throttle.

7. Unplug the cooling water pipe of the throttle valve, and be careful not to drip cooling water into the intake manifold.

8. Loosen the throttle cable and screw the throttle wire, remove the throttle wire, and unplug the throttle control wire and idle motor wire.

9. It can be clearly seen that the front circle of the air inlet adjusting plate is already dark.

10, after cleaning, install it in the reverse order of disassembly.

1 1, check whether all components have been installed, and then connect the negative battery wire.

12, it is very important to correct the throttle of the automobile motherboard. The correction method is as follows: Before correction, make sure the gear is in neutral, pull the handbrake, step on the clutch and brake.