Jiayu throttle initialization

The steps and methods for initializing the automobile electronic throttle are as follows:

1, disconnect the negative battery before cleaning;

2. Connect the battery cathode after cleaning;

3. Honda, turn on the ignition switch for 30s and then turn off 15s to complete the initialization of the electronic accelerator;

4. For Toyota, turn off the ignition switch, unplug the EFI and ETCS fuses in the engine compartment fuse box, install them after 1min, and complete the electronic throttle initialization;

5. For Chrysler, turn the ignition switch to the ON position and turn on the power, but don't start it. The ignition switch should be kept in the on position for at least 10s, and PGM will use this time to complete the adaptation of the electronic throttle;

6. Mitsubishi, 1s turn on the ignition switch, 15s turn off the ignition switch, and complete the electronic throttle initialization;

7. For Citroen, put the ignition switch in the M position for 30s (be careful not to step on the accelerator), and turn off the ignition switch 15s to complete the electronic accelerator initialization.

Car Tips: Generally speaking, poor engine acceleration, increased fuel consumption, unstable idle speed, high and low speed and so on are all caused by sludge accumulated on the throttle for a long time; In general, the electronic throttle is generally cleaned every 40000km 1 time.