What is BYD f6 throttle matching method?

BYD f6 throttle matching method: 1, the key will not start when it is turned to the power gear; 2. Let it stand for about 10 second, quickly step on the accelerator pedal to the bottom, hold it for 15 second, and then quickly lift the pedal; 3. Close the key door, remove the key and let it stand for about 15 seconds; 4. Start the car normally and complete the matching.

The matching method of throttle valve is:

1, turn the key to the power position and do not start;

2. Let it stand for about 10 second, and then press the accelerator to the end. After holding the right side 15 seconds, quickly lift the pedal;

3. Close the key door, remove the key and let it stand for about 15 seconds;

4. Start the car normally. Matching is complete.

BYD f6 throttle matching method: 1, the key will not start when it is turned to the power gear; 2. Let it stand for about 10 second, quickly step on the accelerator pedal to the bottom, hold it for 15 second, and then quickly lift the pedal; 3. Close the key door, remove the key and let it stand for about 15 seconds; 4. Start the car normally and complete the matching.

Manual matching method: For the throttle matched by mechanical cable, the manual reset method is adopted, and the telephone switch is turned on and off for many times continuously, so that the vehicle computer can delete the original throttle memory and store new throttle data. If the verification is successful, you can directly hit the vehicle and drive normally.

Power-off matching method: after replacing the throttle, disconnect the negative electrode of the battery for a few minutes, and the vehicle will enter a dormant state. During this process, the original memory of the on-board computer will be restored to the factory settings. However, this method is only applicable to the resistance model, and the trial operation can be normal.

Diagnostic instrument matching method: read the data with a special diagnostic instrument, and then follow the steps to reset the adaptive value to zero, clear the fault code, start the vehicle and run normally, indicating that the matching is successful.

(Photo/Text/Photo: Ask and Answer the Beast) Model Y Model 3 Model X V Li ONE Xpeng Motors P7 @20 19