How to make hollow characters in ps

1. Open PS, click the file toolbar and select New to create a 600x300 file.

2. Click the text tool, set the text size a little larger, and then enter a few words in the file.

3. Click Layer-Text-Convert to Shape in turn to get the effect as shown below.

4. Click the path selection tool in the left column of the software, and then pull from the upper left to the lower right in the file until all words are selected.

5. Click the command to subtract from the shape area, and the file will become the effect as shown in the figure. Then click on the blank position of the file to confirm the change effect.

6. Select the pen tool and choose the option as shown in the figure.

7. Draw several points in the file as shown in the figure.

8. Select the path selection tool and drag the letters in the file up and down or left and right at will.

9. Click the reduced column chart in the Layers panel to hide the extra parts, as shown in the following figure.

10, click on the tool similar to F in the lower right corner, select projection, and set the distance to 8; Select External Luminescence, set the opacity to 50 and the size to 1, and then confirm.

1 1, then create a new text layer and enter a few words at will. Hold down the effect layer you just finished and drag it under the new text layer. At this time, the new text layer also has the setting effect. It's done.