How to remove the pipe on the accelerator of Cadillac xt4?

First, remove the plastic pipe of the air inlet from the Pacific Auto Network, and pry up the middle of the plastic clip with a screwdriver. Then gently pull the whole plastic clip out and the air inlet is removed. Then remove the pipe from the intake hose and loosen the screw near the throttle clamp with an 8 mm sleeve. Then loosen the screw at the other end and remove the air inlet hose between the air cleaner and the throttle.

Throttle is a controllable valve that controls air to enter the engine. After the air enters the intake pipe, it will be mixed with gasoline to form a combustible mixture, and the combustion is successful. It connects the air filter and the engine block, and is called the throat of the automobile engine.

Throttle is one of the most important components in EFI automobile engine system. Its upper part is the air cleaner grille, and the lower part is the engine body, which is the throat of the automobile engine. Whether the acceleration of a car is flexible or not has a lot to do with the dirt of the throttle. Cleaning the throttle can reduce fuel consumption and make the engine flexible and energetic. Whether the throttle should be removed for cleaning is also the focus of discussion among car owners.

There are two kinds of throttles: traditional cable throttle and electronic throttle. The traditional engine throttle control mechanism works by pulling a cable (soft steel wire) or a pull rod. One end of the cable is connected with the accelerator pedal, and the other end is connected with the accelerator linkage plate. The electronic throttle mainly uses the throttle position sensor to control the throttle opening according to the energy required by the engine, so as to adjust the intake air.