What is the reason why Zotye t300 didn't respond when stepping on the gas pedal?

What is the reason why Zotye t300 didn't respond when stepping on the gas pedal? What is the reason why Zotye t300 didn't respond when stepping on the gas pedal? Stepping on the accelerator is not to control the fuel injection quantity, but to control the air intake quantity through the throttle opening, and the on-board computer controls the fuel injection quantity through the air intake quantity. Therefore, if the vehicle does not respond or vibrate when stepping on the accelerator, it is likely that the accelerator of the vehicle has failed, such as the valve is stuck and the accelerator position sensor has failed. The following are the relevant practices about cars that don't respond when stepping on the accelerator: 1. You should immediately step on the clutch and put the shift lever in neutral position, which means that the engine will dry the throttle there and the power will not be transmitted to the wheels. Then you can pull over slowly as usual, turn off the engine and check the accelerator pedal. If it is not stuck by foreign objects or foot pads, but the throttle itself is sluggish, then don't continue to drive. 2. If the power of the car is relatively high and the throttle stays in a relatively deep position, it needs enough braking force to stop the car. If all the above methods are invalid, you can take the following methods after an instant judgment. Put on the low gear and use the resistance of the engine to force the brake. At that time, because the accelerator was still refueling at this time, it was necessary to turn off the engine immediately after shifting to low gear, and the car would obviously slow down because of the resistance of the engine. @20 19