What is the reason for the high idle speed of Wuling Glory?

Excessive air intake caused by throttle: check whether the throttle is stuck by foreign objects and clean the throttle, check whether the throttle cable is rusted and stuck, and check whether the ventilation around the idle motor is normal.

Air leakage of intake manifold: check whether the intake manifold is damaged or not, and check whether the sealing ring of injector is intact. Retrieve the data stream of each sensor. The most important thing is whether the intake pressure is normal. I can only teach you the method here. Only by following these methods can you find the fault accurately.

Matters needing attention when the car is idling

Turn the plug clockwise as far as it goes. Then turn counterclockwise for 3-3.5 turns. At this time, the position is almost the same.

Then install the idle motor and turn the key to the end, that is, turn it to the ON position. At this time, the driving computer will automatically adjust the idle motor.

It takes about ten seconds to start the vehicle. If the idle speed is normal, adjust it in place. If the idle speed is high, it means that the air intake is large, and it needs to be disassembled and turned counterclockwise by 0.5- 1 turn. Then repeat the above actions. If the idle speed is too low or it cannot be started, it means that the air intake is insufficient. At this time, it is necessary to rotate the plug clockwise by 0.5- 1 turn.