Pressure adjustment method of wall-hung boiler water pump

When adjusting the pressure of the wall-hung boiler water pump, we should pay attention to the following aspects:

1. First of all, you need to turn off the water pump and power switch of the wall-hung boiler to avoid circuit problems.

2. Open the front cover of the wall-hung boiler and you can see the water pump cover plate. Open the cover plate of the water pump and you can see the pressure regulator of the water pump.

3. Rotate the pressure regulator through the screw to adjust the pressure of the water pump. When adjusting, it should be noted that the pressure regulator must rotate properly, not too high or too low, so as to ensure the normal operation of the water pump.

4. After adjusting the pressure of the water pump, cover the water pump cover plate and close the front cover of the wall-hung boiler.

5. Finally, turn on the power switch and water pump switch of the wall-hung boiler again to make the wall-hung boiler run normally.

Pay attention to safety when adjusting the pump pressure of wall-hung boiler. If you are not sure about your operation ability, you can seek the help of professionals. In addition, we should always check the pressure of the water pump of the wall-hung boiler to ensure its normal work.