How to disassemble Chang 'an Yuexiang throttle and how to clean Yuexiang throttle?

Chang 'an Yuexiang dismantles the throttle as follows: 1. Before starting, you need to wait for the machine to cool down before starting the following steps. It's not that the ironing machine can't wash clean, but mainly to protect your little hands from being burned. 2. Pull out the car key, open the engine compartment cover and support it. 3. Remove the negative battery lead that must be removed. Otherwise, it is difficult to correct the car motherboard after cleaning. 4. Remove the plastic cover of the engine. 5. Loosen the clamping screw falling into the air pipe with a screwdriver and unplug the air inlet pipe. 6. Remove the three fixing screws of the throttle. 7. Unplug the cooling water pipe of the throttle valve, and be careful not to drip cooling water into the intake pipe. 8. Loosen the throttle cable screw (throttle cable), remove the throttle cable, and unplug the throttle control cable and idle motor cable. 9. It can be clearly seen that the front circle of the air inlet adjusting plate is already dark. 10. After cleaning, install it in the reverse order of disassembly; 1 1. Check that all components are installed. After completion, connect the battery negative wire; 12. It is very important to correct the throttle of the automobile motherboard. The correction method is as follows: before correction, make sure the gear is in neutral, pull the handbrake, step on the clutch and brake; 1) Insert the key and tighten it to the "on" position, and wait for 30 seconds; 2) Turn off the key and wait for 30 seconds; 3) Repeat the above steps 1 and 2; 4) Start the car, run it at idle speed for 3 minutes, steadily increase the throttle to 3500 rpm, keep it stable for 10 second, release the throttle and turn off the key.