Detailed process of ultra-light clay sculpture manual diy

Draw a sketch on the cardboard first, and then start to pinch out the thin sheet and stick it on it with a little latex.

Step two:

For clay on clay, latex is not used, but the position should be determined before pasting. The bottom rock should be layered with irregular small pieces and then pasted horizontally.

Step 3:

Make a cone bottom, make a rock layer, then make a small plant on it, and finally make a small circle and stick it on the cone.

Step 4:

Make two more, similar in size but different.

Step five:

Stick the small flowers on the rocks below.

Step 6:

Just pinch out two beasts and paste them. Because there are too many details, I didn't take pictures one by one. Please forgive me.

Tips:

If there is enough time, it is best to combine the parts after they are finished. Fill the cone with something to avoid collapse. The irregular surface of the rock layer needs to be penetrated by seven needles. The first time I did it, there were many flaws. Everyone should be patient when doing it.