How to clean the throttle valve

Dirty throttle is mostly caused by poor air quality and poor oil quality. Due to the negative pressure, the carbon deposit produced in the process of gasoline combustion will infect the throttle valve, which will make the throttle valve not close well, thus increasing the intake air, causing signal transmission errors, leading to high fuel consumption and engine idling jitter.

Too high cleaning frequency is not good for the throttle. It is suggested that the owner can check the throttle opening every 10,000 kilometers, and clean it if it exceeds the normal range. Also, if a large amount of impurities and dust accumulate on the accelerator, it will affect the intake of the engine, which is most obvious when starting the vehicle.

Therefore, the throttle is easy to get dirty. Too dirty will lead to jitter and fuel consumption. Whether the automobile acceleration and deceleration operation is flexible is closely related to whether the throttle is clean. Drivers should pay attention to the cleaning and maintenance of the throttle.

For large automobile manufacturers, the accelerator can be cleaned by an automatic ultrasonic cleaner, and the automobile repair shop can choose a slightly smaller industrial ultrasonic cleaner, such as a standard single-slot ultrasonic cleaner.

The throttle body is a fully automatic and environment-friendly water-based ultrasonic cleaning machine. Put the throttle body into the cleaning fixture, and complete the whole cleaning and drying project of ultrasonic rough cleaning, ultrasonic fine cleaning, spray rinsing, bubbling rinsing, high-pressure water cutting, hot air drying and cooling according to the established cleaning process. According to the principle of ergonomics, double chain transmission is adopted, and the upper and lower material surfaces are arranged at the same station. For blind holes and through holes, it is recommended to use ultrasonic+rotating system for cleaning. In the rinsing process, the foaming multi-directional water flow is used to flush the system. The above method makes the cleaning cleaner and drying more thorough, and it is an advanced automatic cleaning system suitable for mass production.