Where is the Skoda Ming Rui sensor?

The location of the Ming Rui sensor is as follows: 1. Oxygen sensor: The oxygen sensor is installed on the exhaust pipe to monitor the combusted gas and judge whether the engine is fully burned and whether the mixing degree is too thin or too rich. 2. Wheel speed sensor: The wheel speed sensor is generally located on the front wheel brake disc. It mainly collects the speed of the car to judge whether the car slips. So there is a special sensor to collect the wheel speed of the car to complete this work, which is generally installed on the hub of each wheel. Once the sensor is damaged, ABS will fail. 3. Water temperature sensor: The water temperature sensor is installed next to the thermostat and converts the temperature of cooling water into an electrical signal. Increase the fuel injection or ignition advance angle at low temperature, prevent explosion at high temperature and delay the ignition advance angle. 4. Intake pressure sensor: generally installed on the throttle. As the name implies, the intake pressure sensor senses a series of resistance and pressure changes with the change of engine speed and load, and converts them into voltage signals for ECU to correct fuel injection quantity and ignition timing angle. If it fails, it will cause problems such as difficult ignition, unstable idle speed and weak acceleration.