Pattern winding method of long balloon

The pattern twisting method of long balloons-the making steps of small rabbits are as follows:

Material: 260 long balloons, 1.

1. Inflate the balloon, leaving a small tail with a length of about 8- 10 cm at the end, and tie the end of the air nozzle to fix it.

2. Starting from the end of the air nozzle, twist a "basic twist" about 4 cm long, which will be used as the rabbit's nose.

3. Twist two longer "basic twists", each about10cm long, like a rabbit's long ears.

4. The last two "basic twists" are folded, and the first basic twist is aligned with the rest of the balloon, thus forming a "chain twist"-grab the last two "basic twists" and twist them together. After twisting, it should be as shown in the figure, and the direction of the nose and ears should be vertical. Then, use a small "basic twist" about 5 cm long as the rabbit's neck.

5. Next, two "basic twists", each about 10 cm, will be used as the two front feet of the rabbit. Here, the two "basic twists" should also be folded and aligned, and then the twists should be held together for "interlocking twist".

6. As shown in the figure, the twisted front foot should also point to the front of the body.

7. Then there are three "basic turning points". The first one is about 4 cm long and serves as the body of a white rabbit. The second and third ones are about 10 cm long, which are used as the hind feet of rabbits, and the last balloon is used as the tail of rabbits.

8. Then, put the two front feet of the rabbit between the two rear feet to form a "sitting" rabbit.

Making flower shapes by winding long balloon patterns.

Material: two 260-long balloons, one green is a pedicel and the other yellow is a petal.

1, the yellow balloon expands to the remaining end about 3 cm long.

2. Fold the balloon in half, and tie the air nozzle with the remaining end of step 1 to make the balloon a ring connected end to end.

Adjust the knot to the center of the balloon as shown in the figure, and we will twist it here.

4, twisted into two circles, a bit like a bow. What we just twisted is called "fulcrum"

5. Press the midpoint of the balloon ring on one side of the fulcrum to the fulcrum, and then screw the midpoint and the fulcrum together.

6. Now your balloon is like this, with two small rings and one big ring.

7. According to the method in the fifth step, press the midpoint of the big circle toward the fulcrum, and then screw them together to form four rings.

8. Those are four rings. Tidy them up and make them look like petals. Next, let's learn to make pedicels

9. Inflate the green balloon until the remaining end is about 3 cm.

10. First, make a basic twist about 3 cm long at one end of the gas nozzle.

1 1. After the basic twisting is completed, insert the petal shaft. The basic twist becomes a stamen.

12, rearrange the petals to make them symmetrical and natural.

13. Put a "twist" about 10 cm below the petal.

14. This folding twist forms a leaf. A * * * twist out two leaves.

15. In the same place, another folding twist is used to form the second blade.

16, that's it, a flower is ready.