Honda Crown Throttle Matching Method

Dismantling method of Honda crown throttle;

First, apply a little oil on the fixed metal circlip to prevent the teeth from slipping during disassembly. Remove the metal wire harness ring of the throttle hose. After the hose is removed, the left end is the position of the throttle. Remove the negative battery, turn off the ignition switch, straighten the throttle, spray a small amount of "carburetor cleaner" into the throttle, and then carefully scrub it with a polyester rag or a high-count "non-woven fabric". Deep in the throttle valve, where the hand can't reach, take a rag and scrub it carefully.

When cleaning the throttle valve, it is not necessary to disassemble it, but it is necessary to clean the sealing part of the inlet steam. Idling motor must be removed before cleaning. Cleaning the nozzle and avoiding disassembly have their own advantages and disadvantages. Generally speaking, the maintenance station suggests avoiding disassembly and cleaning to prevent other unnecessary waste, such as replacing the sealing ring or installing other gaskets after disassembly, or leaking oil and gas during disassembly and assembly, which will delay the owner's time.

After cleaning, the throttle will be initialized after installation according to the procedure just removed. After cleaning the throttle, initialization is necessary, because the computer has a memory function when adjusting the throttle opening, because there was sludge blockage before. In order to ensure the air intake, the computer will automatically adjust the throttle opening to keep the air intake in a normal state.

Honda Crown Road throttle matching method:

1. matches the computer, but some models don't match.

2, find the throttle fuse or battery negative power failure.

Put on the brakes, put in gear for a few minutes, or go out for a run. Basically, normal idle speed can be restored.