What if there is water in tractor oil?

If we want to repair the problem of diesel engine oil entering water, we need to investigate the causes one by one. If damage is found, just replace it with a new one. I hope the following answers can help friends in need.

If we want to repair the problem of diesel engine oil entering water, we need to investigate the causes one by one. If damage is found, just replace it with a new one.

1, cylinder liner is damaged

The diesel engine oil is flooded, probably because the cylinder liner is cracked. At this time, the cooling water will directly penetrate into the oil pan of the automobile through the cylinder wall. Of course, it may also be because the cylinder liner sealing ring is aging, so it is necessary to check the sealing performance at this time.

2, the engine water plugging

If the engine is seriously aged due to water plugging, it will definitely leak water. At this time, the cooling water will be directly mixed into the oil pan, so it is very important to check the water blockage at ordinary times.

3. The radiator is damaged

Secondly, if the oil radiator conduit is damaged, it will also cause oil to enter the water.

4. Cylinder gasket is damaged

There is another reason for the oil to enter the water, that is, the cylinder gasket is damaged. Because the fuel in the cylinder is in a high pressure state for a long time, so that the cylinder liner is damaged, then the oil circuit and the water circuit at this time are equivalent to the intercommunication state, thus causing the phenomenon that the engine oil enters the water.

Treatment method of engine after water intake;

1, if the engine is only mixed with water vapor from the air filter, it is not a big problem at this time. We only need simple treatment to clean the water vapor from the air filter, throttle and cylinder.

2. If there is a lot of water in the engine, it will not affect the normal driving, but the sound is relatively loud. It may be that there is a small amount of water in the oil and gasoline. We need to change the oil and clean the engine-related parts.

3. If there is a lot of water, it means that the engine is close to water, not mixed with water, but the car has not started and the engine is not damaged. We need to drain the water, clean it up, then reinstall it and change the oil with it, but the circuit system is unsafe.

Finally, there is another case where the engine can't run after it is started. At this time, the cylinder, connecting rod and piston of the engine have been deformed, so it can be concluded that the engine has been scrapped. We can only replace the new engine or simply scrap the car.