How to clean Toyota Camry throttle, Camry throttle cleaning method

Because the throttle is in the empty filter box, we must open the lid of the empty filter box first. Before opening the cover, we must first remove the pipe connected to the cover. * * * There are three pipes connected to the air cleaner assembly.

The second one is behind the empty filter box. Now unplug the air inlet, first remove the pipe next to it,

The pipe and the retaining ring are stuck in the ring. Just pull the pipe out. Next, clamp the elastic buckle with the carp pliers, as shown in the figure, to make it loose, so that the intake pipe can be removed. Then pull up the air cleaner assembly as a whole. Note that * * * has three sticking points.

As long as you pull it up evenly, don't worry about an accident, because it is buckled. Unplug the air filter assembly, because the throttle valve will be cleaned here, so the air filter inside will not be taken out. As can be seen in the figure, one end of the three buckles is where the buckles go in, and there are three buckles. Take out the tool and unscrew all screws counterclockwise under normal circumstances.

Note that the screws are tight, which is normal. The more you twist them, the looser they will be. Find a container and put the unscrewed screws in order to avoid mistakes when installing them. After all four screws are removed,

In this way, the throttle has been loose, and the hand comes down as soon as it is taken. Get wet wipes and dry towels ready and start wiping the throttle. It's dirty under the accelerator. After cleaning the throttle, clean the intake manifold. The surroundings are very dirty.

Pay attention to touch the throttle plate with your finger and wipe the edge. Wipe the rubber ring with a wet towel and put it away.