How to match Chery Tiggo 1.6 displacement electronic throttle?

There are two methods: 1: reset with a special detector. 2. Manual matching: first click the switch to turn it on, don't start the engine, step on the accelerator to the end, wait for 50 seconds, then release the accelerator, turn off the key, wait for 3 seconds, and then do the above operation three times continuously. Release the throttle for the third time, don't turn off the ignition switch, just start idling ~

This requires the special computer of Chery manufacturer to cooperate, which can only be carried out in 4S shop.

Extended data

First, open the key, step on the accelerator to the end, spray the throttle wall with carburetor cleaner or spray it on the cloth to wipe it by hand. Of course, you can remove the air intake software with a screwdriver and step on the gas pedal after cleaning. If there is no response when stepping on the accelerator pedal, just turn on the negative battery 1 min and install it. Some models can't directly short-circuit the negative pole, so you can check the quality of the electronic throttle. 4S stores are generally clean, relatively simple and fast.

General steps of electronic throttle quality inspection.

1, first of all, whether it is stable from the idle speed;

2, then, neutral boom accelerator boom to 4000 rpm, loosen the accelerator pedal, to see whether the throttle back smoothly;

3. Finally, check whether there is any fault code, and clean the throttle valve, fuel injector and intake branch pipe when driving normally for 4wkm.