How to adjust the pressure relief rod on the water-gas linkage device of gas water heater?

The flow switch cannot be adjusted. Generally speaking, it is a part of molding. If it is broken, it can only be replaced.

The function of water gas connecting rod equipment is to ensure that the knife can only open enough water pressure. The process of heat exchanger is introduced. When the water flow stops or the pressure is insufficient, the natural gas supply path will be automatically cut off to prevent the equipment from burning due to water shortage, which is usually called water and air.

When enough water pressure is detected, start the gas mechanical switch (straw hat pad), start the circuit (general microswitch), and then start the motor, pulse igniter and solenoid valve (gas electronic valve, note that there are two valve gas paths, which are safety requirements and mandatory requirements of national standards).

Extended data:

Instructions for use of gas water heater:

1. Before using the gas water heater, please determine the position of each function knob according to the operating instructions.

2. After the user turns on the water valve, the water heater automatically ignites the hot water. If the water valve is turned on, the water heater will not light automatically. We should immediately close the water valve and check whether the air source is turned on, and whether the water pressure and pulse igniter are working. If the battery is dead, it will affect the ignition of the gas water heater.

3, users need to pay attention to avoid improper operation and make the water heater only output cold water, especially cold water with the conversion function between cold water and hot water.

4. When the water heater is restarted after stopping for about 10 minutes, the hot water may be very hot. At this point, it will take a few seconds for the hot water heater to take a bath, otherwise it will easily burn the skin.