Installing throttle valve

Writing the actual throttle data into the computer motherboard is called throttle matching. In order to better adjust the idle speed of Honda Fit engine, control the fuel injection and adjust the shift point, the computer needs the throttle to input the state data in real time. When the data changes, the computer will automatically adjust the throttle data value. If it exceeds a certain value, the engine will work abnormally. At this time, it is necessary to clean the throttle and write the latest state data of the throttle into the computer board, so that the computer board can adjust its working mode according to the new data. Throttle matching needs to be done by using a special or general decoder. According to the prompt of the decoder, clear the empty original data and identify the new data. It is recommended to clean and maintain the throttle every 15000 km. After each cleaning, you need to learn to make the engine work at its best. Irregular cleaning of the throttle may lead to abnormal idle speed, slow shift, weak acceleration and high fuel consumption. Honda Fit throttle reset method: Method 1:① Turn on the key to the second gear, that is, the gear where the instrument indicates full light. ② After waiting for 20s, step on the accelerator to the end. (3) After maintaining 10s or so, release the throttle. ④ Turn off the ignition switch and pull out the key to complete the initialization. Method 2: ① Turn the key to the second gear and keep it for 30 seconds. ② Turn off the ignition switch and pull out the key. Attention: Wait 15-20s before ignition. (3) Then ignite to see whether the refueling is normal and whether the engine fault light is extinguished. If not, repeat the previous steps. Methods: Pull out two fuses of electronic throttle control system (10A) and electronic fuel injector (20A), and insert them back to their original positions after 30s to reset the throttle.