Excelle throttle voltage adjustment method

The Excelle model 20 1 1 recently increased the engine speed when it was upshifted (refueling and receiving oil and stepping on the clutch to upshift or downshift), instead of keeping it constant and decreasing (the driving habits are the same). Later, the idle motor and throttle were cleaned and the idle motor was replaced, but it still didn't get better. Many repair shops can't help it. I don't know what the problem is. The Excelle model 20 1 1 recently increased the engine speed when it was upshifted (refueling and receiving oil and stepping on the clutch to upshift or downshift), instead of keeping it constant and decreasing (the driving habits are the same). Later, the idle motor and throttle were cleaned and the idle motor was replaced, but it still didn't get better. Many repair shops can't help it. I don't know what the problem is. Hello! I think I've met this kind. When the ignition switch is turned on and the vehicle is not running, the multimeter measures the signal voltage of the throttle position sensor (the two fixing screws of the sensor are loosened), and adjusts the position of the sensor. When it exceeds 0.3V, tighten the sensor screws, preferably 0.6~0.8V When the vehicle is driving, the idle speed will be high, but don't be afraid. Turn off the ignition switch, turn off the engine, disconnect the negative pile head of the battery, 10 seconds later, reinstall the negative pile head, and it will be OK. Looking for 4S with better technical conditions. I don't believe that such a small problem can't be solved. I haven't found it yet. Pay attention. Hello! How many revolutions does the speed increase? Obviously, there is still a small increase! When did you discover this problem? Go to the 4s shop and ask an expert for a test run to see if it is faulty. I just bought a new car with this problem. I asked many old drivers and repair shops what was going on. No, it seems that stepping on the clutch will change. That's it. Driving habits. Please try to turn off the throttle before stepping on the clutch to see if it will go up. According to your description, after cleaning the throttle and idle valve, you need to check the engine data through the computer to check the cleaning effect and the action of the throttle and idle valve, so as to verify whether it is related to the abnormal idle failure of your vehicle. As an ordinary driver, these jobs may be difficult to operate. If you have certain professional knowledge, you can try it. It is recommended to go to 4S for inspection and maintenance. There seems to be something wrong with the motherboard. I have encountered it before, and it took a while to get better @20 19.