What are the functions of the three plugs (a six-pin plug, a three-pin plug and a two-pin plug) on the ignition coil of 04 GL8?

The six-pin module is connected to the PC board PCM to provide the ignition control signal of the module.

These three pins are signals from the crankshaft position sensor (from 7X) and are used to provide ignition correction signals to the module.

These two pins are power lines (1 powered by No.22 fuse, 1 for hot wire) to supply power to the module.

04 GL8 ignition coil (to be exact, it should be called ignition module) is an integrated ignition module and ignition coil.

If there are only two 3-pin 4PIN connectors in the current video card jumper, you need to use two 4PIN power supplies.

If the power supply of your computer is only 1 connector, you need to buy a patch cord with only 1 3 pins at one end and a graphics card at the other end.

If you don't change it, plug in the 1 three-pin adapter directly, then the three pins at the 6-pin end will be empty, which can't meet the power supply requirements of the graphics card.