How to match Fiat's replacement valve body computer?

After replacing the throttle, disconnect the negative battery for a few minutes, and the vehicle will go into hibernation. During this process, the original memory of the on-board computer will be restored to the factory settings. Then reconnect the battery negative power cord and start the ignition test run normally. 2. If you have the 5053 data cable at hand, the method is as follows: VCDS 10.6.3 software, enter the "Engine" module, enter "Match", enter "000" in the channel number, and then click OK (the purpose of this is to clear the memory data of the original ECU about the throttle).