Traditional Culture Encyclopedia - Traditional culture - Which god knows the technological process of FRP sculpture?

Which god knows the technological process of FRP sculpture?

The first step; Model making, this paper takes FRP relief as a case to further share the production technology of FRP sculpture. The model is the first and most important step. The sculptor shall strictly follow the drawings signed and confirmed by Party A ... The final mud competitive presentation effect shall be confirmed and adjusted by Party A himself.

Under the principle of total construction period, the production period shall be adjusted according to Party A's requirements until the model is determined, before the next step of construction can be carried out. The normal construction period depends on the amount of relief and the degree of difficulty.

The second part; Model replication; Usually, gypsum is used as a mold. Under special circumstances, if you need two pieces, you can use the silica gel mold to make silica gel abrasive dozens of times. Model making ensures the sculptor's rich experience and makes the product more complete.

The third part; Product production: firstly, the gypsum mold is cleaned and waxed. Generally, diesel oil is combined with floor wax, so that the products out of the mold are better, cleaner and easier to clean. The general principle of brushing FRP for the first time is not to be too thick, and the thinner you brush, the thinner you brush. Wait about 20 minutes to dry, and then brush the glass fiber reinforced plastic for the second time. When the second time is about to be fixed, you can stick glass fiber and then put the steel pipe on the back to fix it.

The fourth step; Coloring treatment; In this case, use copper color and use some paint, gold lacquer and gold foil. The reasons are all figured out. Remember the repulsion between alkyd paint and nitrocellulose paint? Propylene is widely used. The color should not be too thick, otherwise it will be easy to delaminate.

The fifth step; Last step, install! The installation in this period is still a little high. Ordinary installation uses expansion screws, users use electric hammers to drill holes, and the expansion bolts are chiseled in, and more points are fixed to ensure firm installation.