How to disassemble the electric pressure cooker?

1. Remove the lid of the electric pressure cooker, with the bottom of the cooker facing upward, and remove the red cross screw below (be careful not to touch the red reset button to avoid overheating).

2. After removing the screw, gently rotate the valve cover clockwise to remove the bottom protective cover. The removed valve cover and screws are as follows

3. After removing the cover, start to remove the fixing screws on the base, as shown by the red circle in the figure. The screw has a flat pad and a spring pad.

4. Tighten the following six pin joints and pull them off the board. This is connected to the operation panel, and the back of the operation panel will be disassembled. Be sure to pull it down.

5. Take out the black base of the pressure cooker. There are no screws, but all hooks are fixed, as shown in the figure below.

6. After taking the base out of the pot, pull out the power cord connector and small board from the base. Be careful not to pull the power cord when disassembling, or you can't put it back without soldering iron and solder.

7. Next, take out stainless steel pot. There are four hooks on the upper ring of the stainless steel pot and the pot, as shown by the red circle in the figure below.

8, as shown in the figure below, pay attention to the connection between stainless steel and the pot body and grounding wire, don't disconnect.

9. This step is to dismantle the operation panel of stainless steel pot, as shown in the figure below. Unscrew the four screws in the red circle with a screwdriver and remove the operation panel.

10, this step is to tear off the guide film on the operation panel. In order to avoid tearing, first heat the film with a hair dryer (be careful not to get too high temperature, so as not to damage electronic components), and then tear it off with force.

1 1. Finally, remove the six screws on the operation panel and the cover to complete the operation panel. At this point, the disassembly of the electric pressure cooker is completed. If installation is required, please follow the above steps.