What are the general steps of turning processing The general steps of turning processing introduction

1, before the operation of the work before the strict use of protective equipment in accordance with the provisions of the tie cuffs, not allowed to scarves, gloves, female workers hair defense should be pulled in the hat. The operator must stand on the foot pedal. Should be all parts of the bolts, travel limit, signaling, safety protection (insurance) devices and mechanical transmission parts, electrical parts, the lubrication point for strict inspection, to determine the reliability of the start. 3 all types of machine tool lighting application of safe voltage voltage shall not be greater than 36 volts.

2, work, clamps, tools and workpieces must be clamped firmly. Various types of machine tools, after driving should be the first low-speed idling, all normal before formal operation.

3, machine tools on the track surface, the table is prohibited to put tools and other things. Not allowed to remove iron filings by hand, should use specialized tools to clean.

4, the machine tool to observe the surrounding dynamics before starting, after the machine tool is started, to stand in a safe position to avoid the machine tool moving parts and chip splash.

5, all kinds of machine tools in operation, not allowed to adjust the speed change mechanism or stroke, may not touch the transmission part, the movement of the workpiece, cutting tools and other work surfaces in processing, not allowed to measure any size in operation, prohibit the transmission part of the machine tool across the transmission or take tools and other items.

6, found that there is an abnormal ringing, should be immediately stopped to repair, not forcibly or with sick operation, the machine tool is not allowed to use overload.