How to use the manual plasma cutting machine?

1. First, make preparations, install plasma equipment and connect compressed gas.

2, according to the thickness of the cutting plate or other parts, size specifications, set the required current.

3. Then, draw a line on the board and prepare the cutting sequence in advance.

4. Connect the grounding wire with the part to be cut, and complete the loop.

5. Hold the clamp and gently move the switch wire on it. When the gas is ejected, take the protective tools and prepare for cutting.

6. Because when cutting, there will be a slit of about 2 mm at the cutting place, so pay attention to the position of the arc when cutting, and try to make the edge of the arc coincide with the line drawn in advance.

7. The size of the weld thus cut is more accurate.

Extended data:

Matters needing attention in using manual plasma cutting machine:

1. If there is an emergency during operation, please press the red emergency stop switch immediately to prevent accidents.

2, maintenance of CNC cutting machine should pay attention to the technician command and coordination.

3. Close all air valves before shutdown, and discharge the residual gas in the gas path.

4. If pipeline backfire is found, power off immediately.

5. Before starting the machine, check whether the machine pipeline leaks. Do not start the machine if there is air leakage.

6, after starting to check whether there are obstacles on the working face and guide rail, if there are obstacles must be ruled out.