How to make a slingshot

How to make a slingshot is as follows:

1. Prepare boards, saw blades, rubber bands, sandpaper, etc.

1. Draw a Y-shaped Mu Cha on the board, and then saw it with a saw blade.

2. Process the Y-shaped Mu Cha and clean the edges. If there is unevenness, polish it with coarse sandpaper first, and then polish it with fine sandpaper. Finally, tie the polished paraffin tightly with cotton rope or cloth to wrap the slingshot and pull it back and forth. You can see that the slingshot is very bright after cleaning.

3. At the distance of 1cm above the slingshot fork, just wrap a rubber band, usually two. Leave one centimeter at the joint of one end and the other end of the two rubber bands, and then tie them tightly with cotton thread. After the two sides are tied, tie the slingshot leather bag, find the position where the top of both sides of Mu Cha is about 1 cm downward, and tie a knot around with rubber bands.

Matters needing attention in making slingshots

1, be sure to pay attention to safety when making slingshots. Don't make the slats too sharp to avoid injury. In order to ensure the accuracy of the slingshot, it is necessary to check its scale and the tightness of the elastic rope regularly. If the elastic rope is too tight or too loose, it will affect the shooting effect of the slingshot.

2, when using a slingshot, to comply with the safety operation procedures. Only in a safe environment can you practice aiming and shooting. Never practice live ammunition aiming in densely populated places or downtown areas. The rubber band must be close to the pencil, otherwise the slingshot will be easy. If you find that the slingshot is not accurate, you can try to adjust the tightness or recalibrate it.