How to tie the line after the first section of traditional snakehead fishing

There are many fishing groups in Luya, and the use of fishing groups is different according to the difference of fish and search water layer. So how do you tie the lines of different fishing groups? How to tie the Lei Qiang knot? These are all problems that novice Luya has to face. Here, I will introduce Luya's skills of tying hooks and lines, and tell you how to tie bait.

Illustration of binding method of Luyalei frog

Leiwa is a bait in reed bud fishing method, which is mainly suitable for Leiqiang fishing method. Many anglers on Huiluya will use it to catch snakehead with particularly sharp teeth, but the main line is often broken due to the strong struggle of snakehead. Because there are many obstacles in the fishing environment in Lei Qiang, the line group is easy to be worn. Therefore, in Lei Qiang fishing method, we should not only choose a fishing line with large pulling force to reduce wear, but also weave several kinks at the front to avoid being broken by snakeheads when fishing.

1. Thread the braided coil on the main line into the connecting ring of the thunder frog.

2. Pass the thunder frog out of the coil on the main line.

3. After the thunderfrog is worn, tighten the main line to tie the slipknot to the thunderfrog connecting ring.

4. Complete lightning frog slipknot.

There are many kinds of Lu Ya, including hard bait, metal bait and compound bait. Luya sequins can be thrown far away on the clear water, and the take-up speed can be adjusted according to the actual situation, which is especially effective for some fast-swimming predatory fish.

1. To find a thin thread, make a loose coil first.

2. Find one end of the thread and thread it into the hole of the sequin.

3. Then grab the pulled thread.

4. Thread the coil just tied.

5. Then grab the thread, cross it on the other side and wind it into a twist.

6. After winding, tie a knot and you're done.

Binding method of Lua lead hook

Different weight specifications of lead hooks will lead to different diving speeds, which need to be determined according to different fish and water conditions.

1. The picture below shows the situation when the tail-winding maggot and the lead hook are separated. Before installation, you must choose a lead hook and a tail-wrapped maggot with appropriate size, and then match them.

2. First, press the head of the maggot on the lead position of the lead hook, and then measure the position where the hook passes through the worm body, so that the body of the soft caterpillar can remain the same after installation.

3. Then insert the hook tip from the head of the soft worm along the body direction, and don't be biased.

4. After the hook tip pierces the worm, it advances along the axis, and at the same time, the body of the soft worm enters along the shape of the hook strip, so that the hook advances to the previously measured piercing position.

5. When the hook tip reaches the position where it passes, bend the insect body to let the hook tip pass through.

6. When the hook tip completely penetrates the worm, there is a lead cast barb on the hook neck of the lead hook.