Is the green space commonly found in parks real grass? How are artificial lawns made?

You know whether the lawn you see in your life is real or not. The advent of artificial lawns has greatly replaced the existence of real grass. It's a whole new area that no longer requires manual mowing and gluing and weeding.

First, this big bag of white plastic pills is the start of making them. In addition, they add the same proportion of green plastic pellets to add color. After the machine melts the plastic, it squeezes it through a perforated piece of steel at the bottom, which creates a green wire rat that collectively passes through a sink underneath to cool and solidify it. The machine then pulls the strands through a giant comb to separate them from each other and move on to the next station. Here, the roller stretches the bundles until they are as thin as needle grass. This lengthening action also serves to strengthen them.

Secondly, the spools will roll these strands up again when they are finished. Once the spools are full, the crew removes them from the spools and moves them to another shop to be disassembled. Here the harnesses are braided into Doppel Synthesis spun threads to finish before the spun threads are allowed to pass through the guides, which allows them to be spooled up again by the larger spools without any slack occurring. In production. At the bottom of the line, the machine is merging the mesh fabric with the synthetic fabric, at which point the multiple strands of synthetic spun yarn come through a tube to a pro-solvent machine.

Third, the solubilizer is a giant sewing machine with up to 250 needles that hook the spun threads through the mesh synthetic fabric, and they can complete hundreds of rows a minute. As the needles thread the yarn through the synthetic fabric, a knife underneath cuts through the loops of yarn to make it look like real blades of grass. At the normal speed of the machine's operation, this process is much faster than waiting for real grass to grow. To make sure that the spun threads are evenly distributed, an inspector checks the finished turf before the machine sends it to the coated rollers. The rollers first apply the adhesive from the governed grooves and then apply it to the passing turf lining weighing it down to bond the artificial turf to the lining. At this point the adhesive on the surface will be very wet, so it must be dried next. They are gradually moved to the inside of the dryer on multiple rollers.

Fourth, the crew must control the internal temperature very carefully, because too much heat can cause the synthetic blades of grass to melt, as they are sent out to dry. At the same time, hot needles on a giant roller will go around holes in the turf, which will give them the ability to seep water. Now, the workers will go over them one last time to make sure the appearance of the sod is in good shape. They will pull off some of the loose grass surfaces and check them for length. Then, they'll be sent to a device that mimics a soccer cleat.