How to arrange the steel reinforcement of the car wash tank

Car wash tank in structural design, in the sugar on both sides of the concrete embedded B16@150 rebar and the two sides of the angle fixed to prevent the angle up and down displacement. The same inch with B16@200 welding and steel bottom, to prevent the angle left and right horizontal movement.

Steel reinforcement installation in strict accordance with the drawings for the production and installation of reinforcing steel, reinforcing steel connection must meet the norms of reinforcing steel joints lapping, first tie the plate reinforcement and then tie the wall reinforcement. Side with one side of the internal mold, support using three layers of scaffolding to support the side wall and the middle wall template. The verticality of the template meets the specification requirements. After the template installation is completed and the inspection is qualified, the concrete is poured.

Concrete is made of commercial concrete, C35, which is delivered to the working surface by pump truck. The concrete strength must reach the design and specification requirements before removing the formwork. Side mold, in the concrete strength can ensure that its surface and the corner of the floor is not trapped to remove the template and damaged before removing. The use of sacks covered with wine to maintain, the number of times a day to maintain not less than 3 times, not less than 7 days.

Precautions: Strictly control the elevation of the top surface of the concrete of the foundation of the platform of the car wash tank during construction. When the concrete strength reaches the design strength 758 before the next process of construction. Strictly control the structure size and reinforcement spacing during construction. Pay attention to the safety of construction electricity. All personnel entering the construction site must wear helmets. Do a good job of civilized construction site.