How to install lanterns

Question 1: How to install lanterns and tie them with wire?

Question 2: How to install lanterns: bulbs, lamp holders, wires, plugs and adhesive tapes. After the bulb, lamp holder, wire and plug are connected, the bulb is hung in the center of the lantern, and the wire and the hanging beam on the lantern can be glued together with adhesive tape.

Question 3: How to hold this lantern at the bottom for 50 minutes? There are two protrusions on the bottom of the lantern and two grooves on the sleeve. After aligning the protrusion with the groove, rotate the sleeve to the right and tighten it.

Question 4: How to assemble the bought lanterns? 5 minutes 1. Do not install the decorative ring yet. Press the top edge directly and press down. When it is pressed against the bayonet, it will make a snap. Even if you can't hear it, you can feel it, just like an umbrella.

When the sea is spread out, just put the ring in from above.

Question 5: How to install the red lantern? To install a red lantern, you must first install a hook at the place where the lantern is installed, and then hang the lantern. Second, the power supply should be in the place where the lanterns are installed. Third, install switches to control the number of lanterns and power supply.

Question 6: How to install the lantern socket on the balcony? The balcony can be installed with live and zero wires.

Question 7: What's the name of this lantern? 100 how to assemble? Please send me pictures and I will help you.

Question: How to install the led rotating craft lantern? First, put the lid without tassels on the lantern.

Expose the lamp about 3 inches.

Then cover the protruding part of the lantern with tassels.

Then turn it around and fix it.

Then put the cover and tassel cover together.

Question 9: How to install lanterns? Please tell me the specific steps: light bulb, lamp holder, wire, plug and tape.

After the bulb, socket, wire and plug are connected, the bulb is hung in the center of the lantern, and the wire and the hanging beam on the lantern can be glued together with adhesive tape.