Bottom angle leveling method of washing machine

Washing machine is one of the necessary appliances in modern families. In order to ensure the washing effect and the life of the machine, every family needs to pay attention to the correct use and maintenance. One of the important problems is the bottom angle leveling of washing machine, which is the key to affect the stability and working efficiency of washing machine.

The bottom angle leveling method of washing machine is as follows:

1. Find the leveling screws of the washing machine, which are generally located at the four corners of the base. Adjust the height of the machine by turning the screw easily with a wrench or torque hand. Usually we lift our feet from the ground and narrow the bottom of the machine from the floor.

2. Before adjustment, it is necessary to clean the sundries at the bottom of the washing machine. If there is a large foreign body, it needs to be taken out to avoid affecting the leveling effect.

3. Use a level to measure the balance of the washing machine. If any deviation is found, you need to continue to adjust the height of the leveling screw until it reaches a horizontal state.

4. Check whether the bottom of the adjusted machine is close to the ground. If there is a gap, it is necessary to continue to adjust the height of the screw to achieve a perfect fit.

Finally, check it again with a level to ensure that the balance and horizontal state of the washing machine have reached the best state.

It should be noted that every time the washing machine is moved or changed, the flat bottom angle needs to be adjusted to ensure the stability and work efficiency of the machine. In addition, in the process of using the machine, we should avoid leaning to one side, which will greatly affect the stability and even life of the machine.

In the daily maintenance, we also need to clean the sundries and dust at the bottom regularly to keep the washing machine clean. For the old washing machine, if it is found that the leveling effect is not good, it is suggested to directly replace it with a new one so as not to affect the use effect and safety.