What are the methods of installation of curved door wood decoration

1, measuring arc, according to the size provided by the designer in the joinery board cut out the corresponding shape, measurement should be done accurately. Processing template, it is best to start from the edge of the joinery board to open the material, reduce the waste of the board.

2, find a suitable location to open the window hole, and then on both sides of the previously made joinery boards to add a piece of each up;

3, to make an equal length of the wooden square (the length of the wooden square according to the two sides of the level of the distance between the joinery boards to determine the general 5-6cm is appropriate). Connect the two pieces of joinery board with the wooden square;

4, then you can seal the plasterboard on the surface, with carpentry tools special cutting round the plasterboard processing out of the window; sealing the number of plasterboard, with the veneer board will be wrapped around the outside of the wooden square sealed up, and fixed with gun nails;

5, the drive unit and drive wheel installation: with M8X15 screws will drive the fixing plate mounted on the flat steel, and then with M6X15 screws will be installed to the flat steel. Then use M6X15 screws to fix the driving device, driving motor and driving wheel to the fixing plate.

6, idler wheel installation: M8X15 screws will be used to install the idler wheel fixing plate to the flat steel, and then M6X12 screws will be used to install the idler wheel to the idler wheel fixing plate.

7, the door ring theory hanger and belt fastener assembly: each arc door on one side of the upper end of the pulley hanger, the other side in addition to the pulley hanger pulley hanger also need to be fixed on the M4X12 screws on the connecting plate, in the connecting plate and then install the belt fasteners, for the door and synchronous belt connection.

8, door lifting: door fan first with the door pulley hanger installed, and then the pulley and the door hanging on the arc guide. Adjust the vertical position of the door and the gap between the two doors, appropriate and then the door pulley hanger on the skin arc-shaped glass door belt fasteners and synchronous belt fixed, the door will be connected to the drive mechanism together. Note that the belt fasteners and synchronous belt movement direction should be the same.

9, the installation of the door stop: door stop is the door opening and closing of the limiting device, arc automatic door is in a state of all open to determine the position of the door stop, the position is set after the stop will be fixed with screws.

6, idler wheel installation: M8X15 screws will be idler wheel fixed plate mounted on the flat steel, and then M6X12 screws will be idler wheel mounted on the idler wheel fixed plate.

7, the door ring theory hanger and belt fastener assembly: each arc door on one side of the upper end of the pulley hanger, the other side in addition to the pulley hanger pulley hanger also need to be fixed on the M4X12 screws on the connecting plate, in the connecting plate and then install the belt fasteners, for the door and synchronous belt connection.

8, door lifting: door fan first with the door pulley hanger installed, and then the pulley and the door hanging on the arc guide. Adjust the vertical position of the door and the gap between the two doors, appropriate and then the door pulley hanger on the skin arc-shaped glass door belt fasteners and synchronous belt fixed, the door will be connected to the drive mechanism together. Note that the belt fasteners and synchronous belt movement direction should be the same.

9, the installation of the door stop: door stop is the door opening and closing of the limiting device, the arc automatic door is in a state of all open to determine the position of the door stop, the position is set after the stop will be fixed with screws.