Method and sequence of straightening plates?

Straightening is to make the hair dry, but the damage is relatively small.

way

Take a comb with fine teeth and some clips that can hold your hair, and then your hair will start to feel layered and thin.

To pull the lower hair first, you can clamp the upper hair first. After pulling a layer, the clip will loosen the hair and put it down, and then continue to layer. Clamp the excess part, and so on until the hair at the top is finally pulled up. The function of the comb is to comb the hair, comb it down from the root of the hair, spread it out for a certain distance, clip the straight board in, and then straighten it while combing. The straight board should move with the comb. The hair at the back can be pulled aside.

Finally, if your hair is too floating, you can wear less lotion and it's over ~

You might as well have an ion perm. Holding a plate clamp is much more harmful than ions. Step: 1. First, wash your hair and blow dry it.

2. Apply 1 evenly until the hair is soft enough to stretch and drip continuously, about 10- 15 minutes. Just wash it (without shampoo). Blow dry 80-90%.

3. Apply No.2 potion, comb your hair flat, let it stand for 20 minutes, rinse it with warm water (without shampoo), and blow dry.

4. Layer the hair and straighten it with a straight splint. Straight hair splint 180 -200 degrees, the best effect.

5. After straightening, wait 48 hours before washing your hair.