Binding method of hanging rope

1, the first choice is to burn the wire with a lighter.

2. After burning the thread, thread it through the small hole of the pendant.

3. After passing through the small hole, leave a little distance at the root, about 1cm, and wait for standby.

4. Pull back the just-finished thread and hold it with your fingers.

5. Then wind the other end of the thread around this rolled thread. When winding, each turn should be parallel. Do not overlap. Overlapping will not look good.

6. The winding length is about 4-5 times. For more information, please refer to the length of the wire to determine the number of windings. After winding, put another thread through the hole above.

7. Then tighten the other thread below.

8. After tightening, the knot of threading will come out.

9. Cut off the ends of the two wires with scissors, leaving a small piece fixed.

10. Burn the thread with a lighter, and then pinch the thread with your fingers to make it stronger. The knot of the pendant is finished here.

Ten common knots refer to flat knots, single knots, double knots, knotting knots, weighing knots, climbing knots, lasso knots, surgical knots, bows and intermediate knots, among which single knots are the simplest and most common knots, which can effectively prevent slippage. Bow is also the most commonly used, and it is more beautiful after knotting.