Installation method of gas stove closing valve

The shut-off valve of gas stove is one of the indispensable safety components in family life. If it is installed and used reasonably, it can effectively prevent some dangers and accidents caused by gas stove. Next, we will introduce the installation method of the gas stove shut-off valve in detail, so that everyone can know more about the installation and use of the shut-off valve.

First, the preparation work before installation

1. Confirm the layout of gas pipeline. Before installing the cut-off valve, it is necessary to determine whether the layout of the original gas pipeline meets the specifications and whether it is necessary to adjust or replace the pipeline. If the pipeline is found to be aging, deformed or leaking, it should be replaced as soon as possible to eliminate hidden dangers.

2, the correct choice of installation location. The gas stove shut-off valve shall be installed at the joint between the gas stove and the gas source pipeline, with a distance of no more than 2m from the ground and a height of no less than 50cm.

3. Prepare the installation tools. Basically, the tools needed to install the closing valve of gas stove are simple tools such as screwdriver, wrench and spirit level.

Second, the closing valve installation steps

1. Clean the installation position. Remove the sundries and dust at the installation location to ensure that the work area is clean and tidy.

2. Install the air cut-off valve. Install the air cut-off valve at the joint between the gas supply pipeline and the gas stove and fix it with screws to make it firm and stable.

3. Connect the gas pipeline. Connect the cut-off valve with the gas pipeline with a wrench, tighten it and ensure a good seal.

4. Adjust the door hinge. After the acceptance and installation work is completed, it is necessary to adjust the height of the gate, so that the center line of the air cut-off valve is more than 5mm higher than the working face of the gas stove, and it does not hinder the use.

5. test. After the installation is completed, it is necessary to carry out tests to verify the closing effect and air valve effect, so as to ensure that there is no air leakage and danger after installation.

Third, matters needing attention

1, pay attention to prevent air leakage risk. At any time, the gas pipe of the gas stove should be kept firm, and there should be no looseness or distortion to prevent gas leakage.

2. Check regularly. The installation and use of air cut-off valve need regular inspection. If problems are found, they should be repaired and replaced in time.

3. Prevent fire sources. During the use of gas stoves, attention should be paid to prevent fire sources and avoid fire or explosion.

In a word, correct and safe installation helps to ensure the safety of gas stoves and avoid safety accidents caused by gas leakage and other problems. At the same time, it is also necessary to pay attention to the quality and safety problems in the installation process, and regularly check and maintain them to ensure completeness.