How to adjust the most sensitive fishing float for beginners?

How to adjust the drift for beginners

First, you hang a piece of lead on the top of the lead seat enough to let the buoy sink to the bottom of the lead, and then cast the culm to adjust the water line so that the buoy is exposed to the surface of the water for one eye, at this time, the lead seat is presented to touch the bottom of the state, and then take a look at the length of your subline and then in accordance with the formula of the buoy downward distance = subline length + 10CM, carefully trimming the lead skin so that the buoy is exposed to the surface of the water, the number of eyes Dan needs. Dan the number of eyes needed, in accordance with this method of high standard absolutely will not appear to find the bottom of the situation, as for what the single hook tuning, with bait tuning are evolved on the basis of this one, as long as you learn the first method, that the first I can say that the back of the tuning method basically does not change too much.

How to adjust the sensitivity of the fish float when fishing ...

The first contact with the fishing gear is the rod, line, float, hooks, just started on what are blind, some spend a lot of time to material resources, or farther and farther away, some after the instructions, find a straight through, avoiding a lot of curves, take the float, now many manufacturers produce float, all kinds of, all kinds of, all kinds of, all kinds of, all kinds of, all kinds of, all kinds of. All kinds of, all kinds of, many kinds of, let a person pick up dazzling, do not know what to pick the kind of, not recognize the float, do not appreciate its performance, thus, it will cause blind purchase, as well as blind use.

Floaters can be roughly divided into five categories, carbon leg soft, hard tail float, bamboo leg soft, hard tail float, steel leg hard tail float and ultra-long shape float, and its style has, long and short carbon leg long body float, long and short carbon leg short body float, {the float tail also has a long break}, bamboo leg soft, hard tail float, as well as the steel leg, the ultra-long legs ....... ....... And so on.

Different types of float, it has different performance and different uses, such as the selection of the float is used in recreational fishing, the pursuit of performance is not too high, there are a number of their own can read the float has been enough, and in the competition, there are different environments, different fish conditions, each type of float has its own different uses.

Carbon leg soft tail drift, its performance in the water stability, strong wind resistance, drift letter is more real, good down signal, usually in the competitive fishing used to fishing tricky fish.

Carbon legged hard tail drift, its performance in the water tripod body is a little slow, but the downton action and fast, the drift letter is obvious, accurate, is the rubbing bait, pulling bait used for the bottom of the mixed fish fishing.

Bamboo legs short body hardtail drift, its performance in the water turn over fast, drift letter good, in the competition is often used to water skin fishing, playing fast fish with.

Bamboo legs long body hard tail drift, its performance is fast turn over in the water, the drift letter is very strong in the competitive game is often used for float fishing.

The steel-legged hard-tailed drift, with its fast turnover, strong stability, solid drift letter, good downward movement, and strong interception, is often used for bottom fishing for mixed fish.

There is also a special long carbon legged drift, the drift tail is also long, the length of more than 40 ----65 cm, its performance downton action is very good, wind resistance and strong, so that in the big wind and big waves can also be stable as a mountain, in the competition, because of its floating long, in the water can reduce the main line and the drifting line, the main line and the drifting line can be used as the main line. In competitive fishing, because of its long float, the angle between the main line and the float leg can be reduced in the water, thus it can extend the fishing position a lot more than using other floats, and it is often used for bottom fishing for mixed fish. The bottom fishing is also used for bottom fishing.

After choosing a good drift, there are fish fishing, in order to be able to catch a good fish, you must need to adjust the drift, first of all, to put aside the secular concept, the traditional fishing method has gradually been forgotten by the athletic people, replaced by the Taiwan fishing, also known as suspension fishing.

Whether you are drifting with a bait, or drifting with an empty hook, you need to adjust the state of the two hooks without touching the bottom, such as if the hooks touch the bottom of the drift is inaccurate, the beginner should pay attention to this point, but also out of the traditional fishing is a key step.

Double bait drift: This is the most easy to understand a drift, of course, before the drift, first of all, to make sure that you rolled the bait group is basically the same, and then hang double bait half-water debugging, just under water, the float will be subjected to the weight of the bait slowly sink until the drift tail is completely submerged, debugging, as long as you slowly cut off the weight of the lead skin until the end of the drift to show you want to fish a number of eyes, such as a number of fishing a few The drift seems to be the most sensitive at this time, but we have to take into account that the bait we rolled is not the same size, and the bait in the process of launching the water will be atomized some weight, adjusting a few fishing a few will be double bait off the ground, in order to avoid this problem, such as double bait adjusted for one eye, you can fish two eyes. Three, and even fishing to five, six, as long as you like, you can fish straight to the lead fall into the traditional fishing, as long as there is a drift letter, bold fishing blunt no harm, for anglers are not afraid of floating chaos, for fear of floating not moving.

Single hook drift, in the commissioning of only an empty hook, adjust a few fishing a few, first ignore the weight of a hook, adjusted and then replaced with a fishing hook set, fishing, let the drift tail exposed to the water surface of the fishing eyes, at this time, the bottom of the hook is sure to lie on the bottom of the hook is just touching the ground, this method of adjustment is simple and practical.

Single bait drift, first of all, the empty hook does not bottom, {hanging a bait ball, the requirements of the commissioning of the bait slow atomization}, in the water, the float will be subject to the weight of the bait ball slowly sinking, debugging, as long as you slowly cut off the weight of the lead skin until the end of the drift exposed to the eye you want to fishing {one eye, two eyes or three eyes}, adjusted to hang on the double bait to throw to the fishing area, the float will be with the double weight of the bait slowly sank, and then the float upward. Then move the float upward, until the end of the float is exposed to the surface of the water (1-men, 2-men, 3-men) of the fishing mesh, this drifting method absolutely guarantees that the lower bait group to the bottom, while the upper bait group is suspended, the weight of the two baits that is not due to the lack of buoyancy of the float will not be sunk, and even less because of the blind adjustment of the number of fishing and the buoyancy of the float will not be caused by the over buoyancy. Appear bait group not in the end and find not in the end of the phenomenon, the purpose of this method of adjustment is to let the weight of the bait group half to let the buoyancy of the float hanging,....... >>

Newbie, ask how to adjust the drift most sensitive

The smaller the residual buoyancy, the more sensitive, theoretically. This should be based on the actual situation to

Beginner fishing drift how to adjust

Empty hook off the bottom, the tip of the drift and horizontal, fishing dew two eyes, this time the fish hook is light touch bottom state, fishing group sensitivity

I am a beginner in fishing, the drift how to adjust, what are the steps

There is nothing is

① Prepare the fish hook and line

②

①Prepare the hook and line

②Tie something on the line that will float

③Put the worm on the hook

④Then throw it out

⑤Wait for the fish to eat

⑥The fish to eat those floats will be a little bit of movement move a little bit

⑦Wait for the fish to bite the hook at this time, you feel, there is a gravity down, then you then use a little bit of force to pull it up.

What kind of float high sensitivity, at the same time, how to see the dynamics of the float to determine when to lift the rod

Now popular with the kind of jujube type of float, sensitivity is very high, the drift type reference to the big Buddha hand float, general fishing float adjusted after the mouth should be a good fish.

How to adjust the drift in wild fishing

1. Drift adjustment:

This refers to setting the equilibrium point where the drift meets the water surface by adding or subtracting the weight of the lead pendant in the line set. There are many different ways to adjust the float, depending on the angler's philosophy and understanding of the float, and each has its own rationale, so it's hard to say which method is right and which is wrong. However, when you are fishing in different conditions or fishing for different species, if you are used to using the drifting method that doesn't work, it's a good idea to change it in time.

2. Drifting with bait:

When drifting with bait on both hooks, the length of the water line is controlled so that the bait ball does not touch the bottom and the bait is suspended. Suspended in the water of the double bait, its self-weight has been balanced out by the buoyancy of the float, the self-weight is zero, in the water fluttering. When the fish swims close to the bait, the current can drive the bait to move and cause the float to be displaced. People who use this method of float adjustment are, ideologically speaking, in pursuit of absolute sensitivity, always hoping to catch the fish at the first action of eating the bait. However, excessive sensitivity also brings certain side effects - the false signals of the float increase significantly, and the fluttering float will make you dizzy and confused.

Although the bait drift will cause the float false action increase, but not without a countermeasure, using the adjustment of the spirit of fishing blunt art can be dissolved false action trouble. For example, hanging double bait tuning one eye, you can fish two eyes, fishing three eyes, or even fishing five eyes, fishing six eyes, as long as the floating signal, bold fishing blunt no harm. For the angler is not afraid of the float moving, is afraid of the float does not move.

3. Drifting without bait:

Drifting without bait can also be described as empty hook drifting. In addition to the double hook without bait, other places with the same bait drifting. The guiding principle of this kind of drifting is to ignore the weight of the bait and let at least one bait ball fall to the bottom when fishing. This drifting method is commonly used by competitive anglers. Its advantage is that the spirit of blunt **** exist, both offensive and defensive, against the smooth mouth fish have a certain effect. Of course, this drifting method is only in the competitive fishing pool when fishing for crucian carp, in natural waters fishing for other species of fish is a mixed victory and defeat, there is no absolute advantage. Whether it is with bait drift, or without bait drift, must be carried out under the premise of double hooks do not touch the bottom, hooks touch the bottom, out of the drift is inaccurate, beginners must pay extra attention to this point.

4. Single Hook Drifting:

Cut off the bottom hook before drifting and keep only one hook. People who like to use this method of drifting, emphasizing that when fishing must let one hook lying in the water, the other hook touches the bottom, and do not need to be so around the brain between tuning and fishing. This method is simple and practical, and is used by most middle-aged and older people.

For example, if you are used to fishing for three eyes, then adjust the single hook to three eyes in half water, ignoring the weight of one hook, and then change to a pair of the same subline after adjusting. Let the float show the surface of the water for three eyes when you are fishing, at this time the bottom hook must be lying on the bottom, and the top hook also touches the bottom.

5. Real fishing state drift adjustment:

The whole process of drift adjustment must be completed in the actual fishing state.

(1) Adjusting the drift in the fishing spot after determining the fishing spot;

(2) Adjusting the drift with the line set you want to use;

(3) Adjusting the drift with a big line in the water when you are actually fishing.

(4) Be sure to adjust the drift after the float and line are fully drafted (after half an hour of immersion), otherwise there may be a difference of one or two points for a highly sensitive float.

6. Half-water drifting:

It means that the double hooks must be in suspension when drifting, not that the water line is half of the water depth. For example, in the water depth of two meters to adjust the drift, and not let you use a meter long water line to adjust the drift, to really adjust the drift, may be the reverse is not allowed. Because when you are adjusting the drift, there is a meter of waterline weight is not counted in the counterweight, for a high sensitivity float, it may be more than one eye difference.

7. Rough adjustment:

It means that before officially adjusting the float, you should roughly adjust it first, and then cast the rod and hit the nest while soaking the float and the line, and then officially adjust the float after half an hour; because the float and the line have micropores, and they will absorb a certain amount of water when they enter the water, and this rough adjustment is to let the dry float and the dry line fully absorb the water and then adjust it carefully to ensure that the drift is adjusted accurately.

8. Micro-adjustment:

Micro-adjustment is generally found in the actual fishing after the drift adjustment, the float language is not too accurate, and add or subtract a very small amount of lead or up and down a tiny amount of moving the float. For example, when you find that the float has a signal, lift the rod but can not hit the fish or often happen to lift the rod on the bottom of the water to run fish phenomenon, you can not adjust the lead weight, just move upward one-third of the eye float, that is ...... >>

How to adjust the float out of the clear mouth of the dengkou Beginner competitive fishing must see

Teach you a simple method:

In the case of ensuring that the two hooks do not go to the bottom of the situation, through the increase or decrease of the lead method will be adjusted to the float to the 5 eye, and then hooks hooks hooks bait, thrown into the fishing point, at this time, because hooks hooks hooks bait, the two small bait group is a weight, so the float has no The float no longer has 5 eyes, it may only have 3 eyes.

Next, pull the float upwards and cast both hooks into the spot, repeat these two steps until the float is at 4 eyes.

Note: The size of the bait should be the same every time you hang the bait.

Good luck

Beginner fishing how to adjust the drift and how to see the drift rod and the essentials

Beginner fishing float adjusted some of the better, adjusted half an eye or so, fishing for two eyes, the float big send drift or black drift rod, catch the dead mouth.