What is the method of garden brick oven?

Before construction, the brick should be watered and moistened 1 to 2d in advance, and the water content should be 10% to 15%. During construction, the substrate should be leveled according to the design elevation, such as the thickness is thicker, C20 fine stone concrete should be used for leveling. Elevation control using the method of pi pole, pi pole from ± 0.000 downward calculation, and according to the pi pole line masonry, wall thickness of 370mm and above is suitable for double-sided hanging line masonry. Foundation brick masonry should be masonry at the same time, can not be masonry at the same time and must be left at the temporary interruption, must be built into a slanting hew, the length of the slanting hew should not be less than 2/3 of the height; hewing, hewing must be cleaned up the surface of the hewing place, pouring water to moisten and should be filled with solid mortar to keep the mortar joints straight. Masonry is appropriate to adopt the "three one" masonry method; when using mortar hair masonry, the length of mortar shall not exceed 750mm; during the construction period when the temperature exceeds 30оC, the length of mortar shall not exceed 500mm. brick masonry should be staggered on and off, inside and outside of the overlap masonry, masonry mortar joints should be vertical and horizontal, thickness uniformity, and horizontal mortar joints shall not be less than 80%; vertical joints shall not be less than 80%; vertical joints shall be filled with mortar, to keep the mortar joints straight. Shall not be less than 80%; vertical joints should adopt extrusion or grouting method, no transparent joints, water grouting is strictly prohibited; masonry with special requirements, the fullness of the gray joints should be in line with the design requirements. Horizontal gray joints and vertical gray joints thickness should be 10mm, but should not be less than 8mm, and should not be greater than 12mm.