Slingshot making tutorial

Slingshot making tutorial is as follows:

1. Draw a picture on it first and measure the dimensions of each part. Contrast wood. Cut out the drawings. Put the pattern on the wood and stroke it with a pencil. Check again whether the slingshot pattern drawn is standard.

2. Draw several drilling points on the edge of the figure. Blink at the mark with an electric drill. Boring wood. Went to the vice and sawed off the wood blank along the drilled hole. Slingshot blanks were sawed off. The remaining wood is reserved.

3. the wood should be y-shaped, and it is best to be strong. You can choose to use elm fork and hand saw;

If the fork is dry wood, you can peel it directly. If it is wet wood, tie the three ends tightly with iron wire, then boil it with salt water or dry it in the shade and peel it (after the salt water is boiled, seal the three ends of the fork with wax and dry it in the sun or oven).

5. Draw the shape of the finished product we want to make with strokes on the Mu Cha; Draw the arch eye with a pencil. Drill a hole with an electric drill. Drill carefully and slowly so as not to crack the wood. Enlarge the arch eye to12mm with a small assorted file;

6. Make a rough look with wood (you can cook wax without boiling it after breaking it up, and finally it is better to apply super glue);

7. Carve a rubber band groove with a knife, fine repair it with a steel file, or polish it with 60 mesh sandpaper;

8. Polishing with 300,800 1000 mesh sandpaper, and finally coating with super glue to prevent cracks and insects is basically completed.