How to cut paper cuts (fish)? Do not be too difficult Oh ~ process to figure (additional 100 points)

Steps in the production of paper cutting

1, draft:

After the idea is determined, the draft layout, a specific picture of the picture, drawing black and white effect. Modified part of the available white powder. For beginners, the finer the draft, the more trouble-free carving. If you carve a symmetrical manuscript, half of the painting can be.

2, cut, carve:

If you carve with a knife. Must be the picture and paper stapled, the four corners fixed in the wax plate, in order to ensure the accuracy of the image, the characters first carve the parts of the five senses, birds and flowers first carve the fine or tight, and then from the center of the carve slowly to the surrounding area, the order of the knife, as in the same way as the writing from the top to the bottom, from the left to the right, from the small to the large, from the small to the rough, from the local to the whole. Try to avoid repeating the knife, don't want the parts must be carved off, can't use your hands to tear, otherwise, the paper will be with burrs and affect the beauty of the cut.

3, reveal away:

Cutting carving is completed after the need to unveil the paper cut one by one, electro-optical paper, velvet paper, because of the smooth surface of the paper, it is relatively easy to unveil, a single Xuan paper and powdered paper, because of the lightness and thinness of the paper, but also by the moisture and coloring, easy to stick with each other, it is difficult to unveil, so in the uncovering away from the cardboard must be engraved before gently kneaded, so that the paper is detached from each other, and then the corner of the first paper! Gently uncovered, while uncovering and blowing with the mouth to help uncover.

4, paste:

Revealed from the completion of the finished product still need to paste up, easy to save. There are two methods, the first is to put the paper cutouts flat on the paper, with a brush or a thin wooden bar dipped in paste from the inside out a little bit of sticky, this method can not make all the paper cutouts flat, slow, the advantage of simpler; the second is to put the paper cutouts in turn on the paper, and then dip the brush in the thinned paste, gently brush on the paper to be supported by the paper, pay attention to the paper should not be crumpled, the brush must be less paste, and then very quickly put the brush in a good paste, and then the paper cutouts, and then the brush should be used in a very short time. Then quickly brush the paste on this side of the buckle in the back of the cut paper, gently flattened with your hands, so that all the cut paper flat adhesion in the tray. Gently lift up to dry and store flat. Adhesive in addition to paste, white latex can also be.

5, the finished product modification:

Sometimes in the cut carving will go knife cut bad, especially carved paper. If a large area is bad, it is not easy to repair, such as a small area is bad, you can carve away partially, make up a piece of re-carve. Color paper-cutting dyeing is wrong can not be covered, so also had to dye the bad parts of the carving away, re-supply a piece of dye again. Modification must be done in mind before the knife.

6, copy - lavender sample - sun sample:

There are two methods of copying, one is to put the paper cut sample on white paper, together with the flat in the water, until the water soaked through the paper surface, and does not contain water droplets, will be engraved paper and white paper at the same time pulled out of the The water surface, pasted on the woodblock, and then put the paper face down on the oil lamp to steam, but do not get too close to the head of the lamp so as not to burn. If you need to make more, you can take the method of sun blueprints: the original haggis and brush a layer of liquid (red blood salt and water solution) of white paper, glued together, with two pieces of glass clamped, placed in the sun for 3 a 4 hours, to be developed with water to wash the liquid on the paper, can be reproduced.

And then some additional information

Chinese paper-cut jianzhi.cn/Photo/goodpic/Index.html

Folk art paper-cut fish vector material figure/s/blog_49646349010007fw.html