How to adjust the seven star drift five step chart

Seven star drift how to adjust the five-step chart is as follows:

Seven star drift is mainly used in the site of the condescending, such as reservoir dam dam wall, the bridge, fishing in the fishing ground when the water level is low in the higher fishing position, the higher river bank and so on. Because the fishing position is too high, the vertical drift drift tail visual angle is too small, so that you can not see the small action, then the seven-star drift will have a use.

The seven-star drift comes from the traditional method of fishing, where the lead is heavier and the float will not lift the lead to half-water, but will always sink the lead. However, in recent years, due to the introduction of Taiwan fishing (competitive fishing) into mainland China, it has become a mainstream technique, and the traditional seven-star drift has also been combined with the Taiwan fishing line set.

One, seven star drift selection

Commercial seven star drift can be used (6, 5, etc.). You can also make your own. Use goose feathers (goose wing feathers). Remove all the soft hairs, leaving only the center stalk. Choose the root position and cut it into small sections of about 1 cm equal length, cut more sections for choice.

Choose seven segments that are basically the same thickness and size, and just thread them into the main thread. You can also use small plastic blocks, foam (packaging) broken, choose the same size of the foam ball, homemade methods are many, not to tell. The size of the seven-star drift is determined by the target fish.

Second, the traditional fishing method

1, lead pendant selection: the weight of the lead pendant is slightly greater than the buoyancy of the float. There is no special requirement for the shape of the lead pendant, round, oval, jujube-shaped can be.

2, adjustment: only one way to adjust the position of the seven-star drift, so that the center of a star flag diagonally lying in the water, underwater three stars, three stars lying on the water. Underwater three stars were a certain arc (seven stars overall upward arc is large, overall downward arc is small).

The spacing of each star is adjusted according to the size of the target and the big fish far away, the small fish spacing close. The adjustment of the sensitivity is to adjust the degree of bending of the main line of the three underwater stars. The greater the curvature of the bend, the more obtuse, vertical sagging is the most sensitive.

Three, the new style of fishing

Because I do not know how to call it, so I call it "new style of fishing". In fact, this is a combination of the traditional fishing seven-star drift and Taiwan fishing line group. （

This is the first time I've ever seen a two-hooked fishing line.)

1, line set: The line set used is basically the same as that used in trolling. The difference is the replacement of the drift seat with a seven-star drift. The seven-star drift is actually a large space bean, so there is no need to locate the space bean of the drift seat, but the space bean to mark the depth of the water has to be there.

2, adjust the initial state: adjust the initial state is to adjust the first no bait state, which is similar to the vertical drift adjustment "adjust the eye". Now the seven stars according to a one-and-a-half spacing distribution, and then the drift seat on the heavy lead test bottom (find the bottom).

After finding the bottom (don't forget to subtract the length of the subline), the water depth mark (the space bean above the seven-star drift) should not be moved. You can also find the bottom with a hook and lead, so you don't need to subtract the length of the fishing line. Then move the seven stars down by 10-20 centimeters (make sure both hooks are off the bottom, i.e., "half water").

Adjust the lead with an empty hook and half water (or without a hook and half water), and adjust the lead sheet until the fourth star floats on the surface of the water at an angle. At this time the three stars in the water is basically vertical sagging state. Initial state adjustment is complete.

3, adjust the fishing state: equivalent to the drift adjustment "fishing eyes". The first single hook bait to try the water surface of the three stars sinking a few, so that the heart will have a number. Then move the whole thing back to the depth marker space bean.

Single hook lead (or bait) and then find the bottom (accurate bottom). After finding the true bottom, double hook the bait and adjust the three stars under the water in an arc, the fourth star is tilted to float on the water surface, and the top three stars are floating on the water surface (using the method of adjusting the whole seven stars to move up or down). The fishing position is adjusted, start to test fishing.

4, adjust the spirit of blunt: fishing attitude after adjusting, can only be said to be the seven-star drift "preliminary adjusted", but also through the test fishing, adjusted to the most suitable sensitivity, which may be repeated a few times to adjust. This is to adjust the spirit and blunt. The closer the seven stars are spaced, the faster the response, and the smaller the arc of the three underwater stars (the main line), the more sensitive it is.

So, the spirit and bluntness can be combined with the underwater three stars curvature degree and star spacing comprehensive adjustment. For example, the surface of the three stars were quickly dragged into the water, lifting the rod empty hook, indicating that it is too flexible, increase the distance between the stars, increase the curvature of the main line of the underwater three stars. Increasing the arc is to move the seven stars as a whole upward, and decreasing the arc is to move the seven stars as a whole downward.

After adjusting the seven-star drift, you can't fish to the bottom once and for all. Because the seven-star drift and the same as the vertical drift, there is also the problem of "draught", and the seven-star drift draught is much more serious than the vertical drift. So, after fishing for a while, you should check the initial state and fishing state, and adjust timely if there is any change.

The above method is just a "method" and should not be taken as a "standard". For example, you can adjust the initial state of the surface floating five stars, or the surface floating two stars. Specifically how to adjust the drift, according to the actual situation, for the characteristics of the target fish to make appropriate adjustments.