Method for make hand-woven flower basket

1. Cut the woven belt into four sections with the same length (the length depends on the size of the basket you want to weave, length = bottom diameter +2 height+10cm), and mine is 45cm long. Braid the braid as shown in the middle, and tie it with a string for easy fixation.

2. Cut the tape in half.

3. Knit a circle up and down with the belt cut to the width of 1/4 (the bottom can only be woven flat with thin tape).

4. Make a second ring with another belt, which is opposite to the top and bottom of the first ring.

5. In the third lap, the side weaving is tightened, so that the previous lap can be fixed.

6, the fourth lap, the fifth lap ... like this, and try to adjust the blue evenly.

7, until you want the size, cut off the excess tape.

8. Fold the blue ribbon like this.

9. Weave the side with the belt cut into 1/2 width, cut the beginning part into an inclined plane and connect it with the bottom as well as possible.

10, it's better to line a flowerpot with a suitable size in the middle, so as to control the shape better.

1 1, the joint parts are connected in this way, and they will be fixed at the end of the next cycle.

12, after reaching the required height, cut into inclined planes and close the head to make the upper edge as flat as possible.

65438+

14, look, it has been compiled, and this is what it looks like inside.

15, this is what the bottom looks like. It doesn't matter if it's a little rough, just press the heavy object for a few days.

16. The duckweed planted this year is quite suitable.