How to connect the speed control switch of ceiling fan?

The wiring method of ceiling fan speed regulating switch is as follows:

Tools/raw materials: ceiling fans, wires and adhesive tapes.

1. First, you can find another thread and tie one end with two threads, as shown below.

2. The other end of the wire passes through the boom, as shown in the figure below.

3. When the wire reaches the bottom, pull it hard until the wire comes out and is connected, as shown in the figure below.

Maintenance method of ceiling fan

First, clean regularly.

Ceiling fans will accumulate dust and dirt during use. If it is not cleaned in time, it will not only affect the wind power and operation effect, but also cause air pollution. Therefore, every once in a while, clean the blades and fuselage of the ceiling fan with a soft cloth or brush. You can use some detergent or cleaning solution, but you should pay attention to avoid water droplets from entering the motor part to avoid damage.

Second, lubricate regularly.

The rotor and bearing of ceiling fan may rust and wear after long-term use, which will affect the operation effect and produce noise. Therefore, it is necessary to add proper lubricating oil to the shaft and bearing of the ceiling fan every once in a while to reduce friction and noise and maintain a good running state.

Third, check the wires and switches regularly.

The ceiling fan is driven by electric energy, so the wires and switches are very important parts. Check the wire regularly for damage, short circuit or poor contact, and repair or replace it in time if there is any problem. At the same time, always check whether the switch is flexible and reliable, so as to avoid failure during use and affect normal use.